Cozzia CZ-361 Manuel D'utilisation Et D'entretien page 7

Use and Care Manual
Wellness for Home
Step 3:
• Connect backrest heater wire and seat vibration wire.
Step 4:
• Put away the component carton and take all the parts out from it. Put the remote controller
into the pocket of left arm.
Step 5:
• Remove the bolt and split pin from the backrest actuator and set aside.
Seat vibration wire
Backrest heater wire
Step 6:
• Attach the backrest to the seat base. DO NOT rest it on the floor vertically otherwise
damage to the backrest will occur. Make sure that the seat is at its most upright position when
resting the pivot pins to the cradle points on the seat base.
Step 7:
• Use the bolt to attach the backrest bracket to the actuator and secure with the split pin.
A: Connecting rod
B: Fork
C: Flat head rivet
D: Split pin
Step 8:
• Connect the air hose and backrest cable (black and grey).
Backrest cable
10/11
Air hose