Publicité
Les langues disponibles
Les langues disponibles
y Begin by positioning the 5570-BATT Non-Rechargeable Battery Carrier
with the arrow pointing to the left. (Image 4)
y Using the thumb and index finger, squeeze in on the two sides of the
carrier cover closest to the right end of the carrier. (Image 5)
y This action will cause the tabs on the right end of the cover to release
from the base and allow the cover to simply lift away. (Image 6)
y Using 6 – AA Energizer EN91 or Energizer E91 (make sure that all 6
Image 7
batteries are of one or the other model...do not use a combination of the
two), install the batteries per the diagram located on the inside base of the
battery carrier. (Image 7)
y Take care not to bend any of the battery contact springs, and to make
sure that all 6 batteries are properly seated before reinstalling the cover.
(Image 8)
y To reinstall the cover, insert the two tabs on the left-hand end of the
cover into the two corresponding slots on left end of the base. (Image 9)
Image 10
y While keeping the left-hand tabs in their slots, gently press down on the
right side of the cover until the two right-hand tabs slip into their respective
slots. (Image 10)
NOTE: The battery carrier cover will only fit one way. It is not possible
to install it in a reversed position.
The 5570-BATT Non-Rechargeable Battery Carrier is ready to install
into the Angle Light.
Installing the Non-Rechargeable Battery Carrier
y With the Battery Compartment Door opened enough to provide
clearance, insert the 5570-BATT Non-Rechargeable Battery Carrier with
the end having the metal contacts on it being inserted first and the rails
on the bottom of the battery carrier positioned toward the back of the light.
(Image 11)
y With the battery carrier fully inserted into the handle of the light, close
the Battery Compartment Door and secure it in place with the Battery
Compartment Door Screw and the included Torx Wrench. (Image 12)
WARNING: Do not over-tighten the Battery Compartment Door Screw.
OPERATION
THE XPP-5570R HAS EIGHT SEPARATE LIGHTING MODES:
y
y
y
y
y
y
y
Image 13
y
on at the same time)
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.mynightstick.com
Image 8
Image 9
Image 11
Image 12
High-brightness Flashlight
Medium-brightness Flashlight
Survival-mode Flashlight
Flashlight Strobe
High-brightness Floodlight
Medium-brightness Floodlight
Survival-mode Floodlight
Dual-Light (both the Flashlight and Floodlight
Flashlight Modes
To activate the Flashlight, press and release the Flashlight Switch
(Image 13). The default mode will be High-brightness. To select the
brightness level for the Flashlight, press and hold the Flashlight Switch.
The flashlight will cycle from high to medium to Survival and then back
up again at a rate of approximately one mode per second. The light will
continue to cycle up and down through the various modes as long as the
switch is held down. When the desired brightness level is reached, simply
release the Flashlight Switch, and the light will remain in that brightness
mode. To turn the Flashlight off, press and release the Flashlight Switch
one more time.
Strobe
To activate the Strobe, double click the Flashlight Switch (Image 13). To
turn the Strobe off, press and release the Flashlight Switch one more time.
Floodlight Modes
To activate the Floodlight, press and release the Floodlight Switch
(Image 13). The default mode will be High-brightness. To select the
brightness level for the Floodlight, press and hold the Floodlight Switch.
The floodlight will cycle from high to medium to Survival and then back
up again at a rate of approximately one mode per second. The light will
continue to cycle up and down through the various modes as long as the
switch is held down. When the desired brightness level is reached, simply
release the Floodlight Switch, and the light will remain in that brightness
mode. To turn the Floodlight off, press and release the Floodlight Switch
one more time.
Dual-Light Mode
Dual-Light mode allows the user to turn on both the Flashlight and
the Floodlight at the same time. Dual-Light mode can be activated by
simply pressing the Flashlight Switch and then the Floodlight Switch or the
Floodlight Switch and then the Flashlight Switch (Image 13). If the Angle
Light already has the Flashlight or the Floodlight on (regardless of what
brightness mode that light is in), pressing the switch for the light that is NOT
on, will activate Dual-Light mode. The user can leave Dual-Light mode
and go back to either Flashlight or Floodlight mode simply by pressing the
switch for the mode that they wish to turn off. To turn both lights off, simply
press each of the switches independently.
BAYCO PRODUCTS LIMITED LIFETIME WARRANTY
WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in
workmanship and materials for the original purchaser's lifetime. The Limited
Lifetime Warranty includes the LEDs, housing and lenses. Rechargeable
batteries, chargers, switches, electronics and included accessories are
warranted for a period of two years with proof of purchase. Disposable, non-
rechargeable batteries are excluded from this warranty. Normal wear and
failures which are caused by accidents, misuse, abuse, faulty installation
and lightning damage are also excluded.
In the event that Bayco Products, Inc. receives notice that any product
does not conform to its warranty, the original purchaser's sole and exclusive
remedy, and Bayco Products, Inc.'s sole and exclusive liability, shall be
for Bayco Products, Inc., at its sole option, to either repair or replace the
non-conforming product in accordance with this limited warranty. The
original purchaser shall follow the instructions below to qualify for a repair
or replacement product. This is the only warranty, expressed or implied,
including any warranty of merchantability or fitness for a particular purpose.
IN NO EVENT WILL BAYCO PRODUCTS, INC. OR ITS AFFILIATES
OR SUPPLIERS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL
OR CONSEQUENTIAL DAMAGES OF ANY KIND REGARDLESS OF
THE FORM OF ACTION, WHETHER IN CONTRACT, TORT (INCLUDING
NEGLIGENCE), STRICT LIABILITY OR OTHERWISE.
CUMULATIVE LIABILITY TO CUSTOMER, FROM ALL CAUSES OF
ACTION AND ALL THEORIES OF LIABILITY, WILL BE LIMITED TO AND
WILL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT PAID
BY CUSTOMER.
If this product is used for rental purposes, the warranty term is reduced
to 90 days from the date of purchase.
WARRANTY CLAIMS – USA
Return the product to the place of purchase for all warranty related
issues. If this is not possible, contact Bayco Customer Service at (800) 233-
INS-XPP5570-15D
THE TOTAL
Publicité
