Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
Your new automatic pool cleaner contains:
A. Robotic Pool Cleaner and floating cable.
B. Power Supply (transformer)
Please read this Manual completely before operating your Pool Cleaner.
1. Place the power supply (transformer) at least three meters (10 feet) from the pool. (See figure
2). The transformer should not be left out in the rain or placed in puddles of water. The
transformer will supply very low voltage (12V) to the cleaner.
2. Uncoil the cable (See figure 3 ).
3. Make sure that the power supply switch is in the "OFF" position and plug the floating cable into
power supply socket (See figure 4). Make sure the key on the plug exactly corresponds with
the key slot on the socket of the power supply (See figure 5).
4. Place the unit in the water. Turn the unit side to side in the water to allow air to escape from the
body and then let the cleaner sink to the bottom of the pool (See figure 6 ). Then spread the
floating cable over the surface of the pool as
evenly as possible making sure it is not
tangled or kinked
5. Adjust the TIMER CONTROL KNOB on
the transformer to 25 seconds (See
figure 7).
6. Plug the transformer cord into a
230V three grounded outlet (See
figure 8). Switch the on/off switch
button to
"ON" and press the re-set button. The
unit will start cleaning the pool. The
Pool Rover should move across the pool,
at its widest point from one side to
another.
The Pool Rover should wait at both sides
walls of the pool (or any other obstacle) 2
seconds before reversing automatically. If
this does not happen, adjust the TIMER
CONTROL KNOB accordingly.
NOTE: If the 25 seconds is not enough for the Pool
Rover to move across the pool and to wait 2 seconds
before reversing, adjust the TIME CONTROL KNOB at
30 seconds. If 25 seconds is too much and the Pool
Rover waits more than 2 seconds before changing
direction, than adjust the time to 15 seconds (adjust
according to your pool).
8
4
6
7
3
5
2
2
Publicité
