Publicité
Les langues disponibles
Les langues disponibles
Dear Customer,
Thank you for choosing the Pool Rover to clean your flat
aboveground pool. We hope that you will enjoy using your
new Pool Rover to maintain your swimming pool for years to
come.
The Pool Rover is the only aboveground, fully automatic
robotic pool cleaner with a powerful jet drive propulsion
system.
Before you begin to use the Pool Rover, please take a few
minutes to carefully read the Operator Instructions. Again,
thank you for choosing the Pool Rover.
fuse
1
transformer cable plug
floating cable
transformer 115 V only
power switch
ON/OFF
wheel
floating cable plug
socket
re-set button
timer
IMPORTANT
1. Caution: Do not switch the pool cleaner "on" if it is not fully
immersed in water. Operating the cleaner out of the water
will cause severe damage immediately and will result in loss
of warranty.
2.This pool cleaner system has an internal timer, which will
automatically shut off the cleaner after two-hours of operation
in your pool. However the power switch will remain in "on"
position. To re-start the cleaner for another cycle, switch "OFF"
the transformer, wait 45 seconds, then switch it back to "on"
and press the re-set button.
WARNING:
A. Your Cleaner should not be used while people are
swimming in the pool.
B. A ground fault current interrupter or a residential
current device (GFCI) must be installed to protect your
electric outlet and prevent any possible electric shock.
C. Make sure the transformer of the unit is proper for
your outlet voltage (115 V)
body
handle
side plate
jet valve housing
jet outlet
lock pin
1
Publicité
