Publicité
Les langues disponibles
Les langues disponibles
Fixing the barrier
•
Take the top cover off by unscrewing the screws (Fig. 3).
•
Open the barrier wings, position the barrier on the foundation plate making sure that the
lower holes correspond to the screwable rods and screw everything in place with the M10
nuts. (Fig.4).
Fig. 3
Fixing in the aluminium bar
•
Fix down the bar holder bracket without wholly tightening down the screws (Fig. 5).
•
Slide the 80mm diameter barrier arm into the bracket from the opposite side of its lid,
screw in tightly the four M8 screws (Fig. 6) and fix the boom with the M6x8 screw.
•
Assemble the fixing joint on the 80mm bar and insert the 60 mm bar into it.
•
Fix down everything with the provided screws.
Fig. 5
Istruzioni Instructions Anleitungen
Fig. 4
Fig. 6
14
Publicité
