Publicité
Les langues disponibles
Les langues disponibles
DRAINAGE
During the process of cooling, some water will be extracted from the air into the unit.
If the reservoir is full, both
(you can press any button to stop the buzz). The Full Water indicator will flash to show you.
To make the cooling work again, please empty the water by one of the following ways:
1.
Turn off the air conditioner and avoid
moving it when full.
2. Position a container (a water tray for
example) underneath the drain hole.
3. Remove the drain knob & rubber plug from
the drain hole and allow the water to drain
out.
4.
When the container is almost full, replace
the rubber plug in the drain hole and empty
the water tray.
5.
Repeat until the unit is emptied.
6. Replace the rubber plug and tighten the
drain knob firmly.
7. Switch on the unit - the full water or
compressor operating indicator should not
be flashing.
If you wish to operate the unit without the need to empty the water tank, please:
•
Remove the drain knob and rubber plug
and retain for future use.
•
Connect the drain tube supplied to the
water outlet as shown and locate the other
end into a drain.
of the compressor and motor will stop and the units would buzz
Rubber hole
10
Drain knob
Rubber plug
FIG.24
FIG.25
Publicité
