Binzel ABIPLAS CUT 200 W/MT Mode D'emploi page 33

®
ABIPLAS CUT 200 W/MT
Type of wear part
40 – 70 A
70 – 90 A
90 – 120 A
120 – 160 A
160 – 200 A
Tab. 5 Selection of plasma nozzle
1Special wear parts are for ignition-critical power sources and labelled with an 'X'.
Standard values for cutting capacity
Max. material thickness
Low alloy steel
Stainless steel
Aluminium
Tab. 6 Standard values for cutting capacity
1Special wear parts are for ignition-critical power sources and labelled with an 'X'.
Standard length (other lengths available on request) 6 m
Structure
Connection power/air cable
Version
Tab. 7
Cable assembly
Standard
The specifications on the cutting capacity are standard values only as they are
also greatly affected by the following factors:
• Type and quality of the material
• Compressed air pressure and impurities
• Temperature of the workpiece to be cut
• Desired cutting quality
• Condition of the electrode and the cutting nozzle
• Distance and position of the cutting torch from the workpiece
• Power source characteristics
• Cutting speed
Standard
60 - 70 mm at 200 A
55 - 65 mm at 200 A
40 - 45 mm at 200 A
NOTICE
• The lower the pilot current, the longer the service life of the electrode and
the cutting nozzle.
1.2 mm
1.4 mm
1.6 mm
1.8 mm
2.0 mm
50 - 60 mm at 160 A
40 - 50 mm at 160 A
35 - 40 mm at 160 A
Cable assembly/coaxial cable
G3/8
Direct connector or central connector
3 Product description
1
Special
1.2 mm
1.4 mm
1.6 mm
1.8 mm
2.0 mm
1
Special
EN - 9