Moving Lift To Work Area - Marshalltown DL11-11 Mode D'emploi

TO ASSEMBLE YOur LIfT Continued:
3. Place the cradle assembly onto the mast. Ensure that the cradle is locked to the mast
with the locking pin and that it is facing the proper direction.
The lift is normally moved to the job site by rolling on its 4'' casters using the steering
handle. NOTE: DO NOT PULL BY THE LOAD
LIFTING CABLE(S).
MOVING LIFT IN WORK AREA (WITH LOAD)
Although it is best to move the unit to the job site
unloaded, light loads may be transported as long as
the unit is rolled on the casters on a level surface.
Always have the load in the lowest possible position
before moving the unit.
If it is necessary to move the unit with an elevated load:
• Make sure the area is clear of obstructions
• Keep personnel away from the load and behind the operator's position
• Move the unit slowly, avoiding sudden jerky starts and stops
• Make sure the load is secure and properly balanced
If a load is being transported,
CAUTION
it should be secured to the
!
cradle to avoid shifting.
6 6
Phone 800-888-0127 / 641-753-5999 • Fax 800-477-6341 / 641-753-6341 • www.MARSHALLTOWN.com Phone 800-888-0127 / 641-753-5999 • Fax 800-477-6341 / 641-753-6341 • www.MARSHALLTOWN.com
3
frONT
MOVING LIFT TO WORK AREA (NO LOAD)
LOCkING
PIN
Moving the unit with
WARNING
elevated loads should be
!
contained to short distances
(i.e., 10-15 feet or 4-5 meters)
STEErING
hANDLE