Bayco NIGHTSTICK XPP-5420 Mode D'emploi

Operating Instructions For
XPP-5420 and XPP-5422
Safety Rated Intrinsically Safe Lights
INS-5420-12
Thank you for purchasing this NIGHTSTICK product. Save this instruction.
Please read these instructions before using your NIGHTSTICK. It includes important
safety and operation information.
5420 USE ONLY 3 AA ALKALINE, DURACELL PC1500, ENERGIZER EN91, OR
ENERGIZER LITHUM L91. LITHIUM BATTERIES MUST BE REPLACED BY
QUALIFIED TECHNICIAN ONLY.
5422 USE ONLY 3 AA ALKALINE, DURACELL PC1500, ENERGIZER EN91
MODELS XPP-5420 AND XPP-5422 ARE APPROVED FOR USE
cETLus Listed Intrinsically Safe for use in Class I II III Div 1 SECRURITE INTRINSEQUE
Groups A,B,C,D,E,F & G Hazardous Locations
-20C < Tamb <+40C • Ex ia IIC T3 Ga • Class 1 Zone 0 • AEx ia IIC T3 Ga, Zone 20 •
AEx ia IIIC T 165C Da
SPECIAL INSTRUCTIONS FOR INTRINSICALLY SAFE MODELS
For personal safety, always confirm the rating of any known hazardous or potentially
hazardous location where the flashlight is planned to be used. These areas include fuel
storage areas below decks on boats, fuel or chemical transfer or storage facilities and
areas where the atmosphere contains chemicals or particles, such as grain, dust, or
metal powders. Areas with potentially explosive atmospheres may not be posted. If
you are unsure of the environment contact the Safety Director or agency where the
environment in question is located. A listing of the rated classes, divisions, groupings and
zones of gasses, vapors and combustible materials is available in the National Fire
Protection Administration (NFPA) Classification of Flammable Liquids and Combustible
Materials section of the 2004 edition of the NFPA-70 manual. Available at www.nfpa.org
SAFETY
CAUTION BRIGHT LED RADIATION: AVOID DIRECT EYE EXPOSURE. NIGHTSTICK
IS A CLASS 2 LED PRODUCT PER IEC 60825-1 EDITION 1.2.2001.
Do not attempt to repair or disassemble the internal lighting module.
•
Using this NIGHTSTICK product for other than a lighting device is not recommended.
•
Bayco specifically disclaims liability for other than intended use.
OPERATION
XPP-5220B/G
Models 5420B & G have a single switch to turn the flashlight on and off. The switch also
provides a momentary on/off function.
XPP-5422B/G
Models 5422B & G have two body switches that control the flashlight and the floodlight.
The flashlight and floodlight functions can be operated independently and together.
BAYCO • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 00+1+ 469-326-9400 • www.baycoproducts.com
Besides the batteries, there are no user serviceable components in the flashlights.
Warning – Substitution of Components May Impair Intrinsic Safety
•
AVERTISSEMENT : LA SUBSTITUTION DE COMPOSANTS PEUT
•
COMPROMETTRE LA SECURITE INTRINSEQCJE
Warning To reduce the risk of explosion do not mix new batteries with old/used
•
batteries, or mix batteries from different manufacturers
Warning To reduce the risk of ignition of a flammable or explosive atmosphere,
•
batteries must be changed only in a location known to be non-hazardous
AVERTISSEMENT: AFIN DE PREVENIR L'INFLAMMATION D'ATMOSPHERES
•
DANGEREUSES, NE CHANGER LES BATTERIES QUE DANS DES
EMPLACEMENTS DESIGNES NON DANGEREUX
WARNING: Risk of ignition – Do not open in a hazardous area
•
WARNING – DO NOT REPLACE BATTERY WHEN AN EXPLOSIVE GAS
•
ATMOSPHERE MAY BE PRESENT
INSTALLING OR CHANGING BATTERIES
CAUTION
ATTENTION
PRECAUCIÓN
TO REDUCE THE RISK OF IGNITION OF A FLAMMABLE OR EXPLOSIVE
ATMOSPHERE, BATTERIES MUST BE CHANGED ONLY IN A LOCATION KNOWN
TO BE NON-HAZARDOUS
1. Loosen the locking screw located on the side of the lens cap
2. Unscrew the lens bezel.
3. Shake out the reflector / battery carrier.
4. Install 3 AA batteries in the carrier. Use only approved batteries: Duracell PC1500,
Energizer EN91, or Energizer Lithium L91
5. Replace reflector / battery carrier in flashlight housing. Align reflector / battery carrier
with the switch.
6. Replace the lens bezel.
7. Tighten locking screw.
WARRANTY
Limited Lifetime Warranty
Product is warranted to be free from defects in workmanship and materials for the
lifetime of the original owner. Includes the housing, lenses, electronics and switches.
Batteries, normal wear and abuse are excluded.
Not Covered
Consequential damages, incidental damages or incidental expenses, including damage
to property. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you. This
warranty gives you specific legal rights, which may vary from state to state.
Warranty Claims - USA
Contact Bayco for USA warranty claims. Call 800-233-2155 or email
cs@baycoproducts.com and Bayco Customer Service will provide a Return Goods
Authorization (RGA) to facilitate rapid warranty action. After receiving the RGA, send the
product (shipping prepaid) to BAYCO • 640 S. SANDEN BLVD • WYLIE, TEXAS • 75098.
Include a dated proof of purchase and a brief description of the defect with your name,
address and phone number. Your product will either be repaired or replaced at the option
of Bayco and returned as soon as practical, but no later than 45 days after being
received by Bayco.
Warranty questions and international claims
If you live outside the USA or have questions about this warranty or an inquiry about
other Bayco products contact BAYCO • 640 S. SANDEN BLVD • WYLIE, TEXAS • 75098
or call 800-233-2155
Product Information
Date of Purchase ____________________________________________