Control Pad - ray PIKO Serie Mode D'emploi

Manual: RTI PIKO Series

8. Control Pad

The device is equipped with a control touchscreen, the following images explain the use of the
touchscreen. Touch the screen to change the settings.
8.1 Starting sequence
8.2 Main Menu
Laser status, amperage
& interlock status
display
Version and tempera-
ture display
Laser on / off:
Device is enabled /
disabled
Laser on / internal: Laser on / ILDA in:
The different operation modes can be selected The external access
by using the rotating selector next to the Show- through ILDA is ena-
NET-Display (or FB4) at the back of the device. bled
page 10 / 12
Touchscreen
Status display
Back:
Use this button to return
back.
DMX, Adv. and Setup:
Use these buttons for Dmx
settings etc.
Color & Scan Setup:
Use these buttons for co-
lor or scan settings
English
8.3 Color Settings:
+ / -:
Use these buttons to
change the color
intensity
8.4 Scanner Settings:
Y Size vertical:
Use these buttons to
change the vertical size of
the output
Y Shift up/down:
Use these buttons to
change the vertical shift
of the output
English
Manual: RTI PIKO Series
Colors:
Please note that
only implemented laser
sources can be changed
in their intensity. If there is
e.g. no yellow laser source
installed in your device,
changing the intensity
slider for yellow will have
no effect. The intensity
change only applies per
single laser source and
does not change mixed
colors. Please use your
software to change mixed
color intensities.
X Size horizontal:
Use these buttons to
change the horizontal
size of the output
X Shift left/right:
Use these buttons to
change the horizontal
shift of the output
page 11 / 12