Publicité
Les langues disponibles
Les langues disponibles
2. Be aware that this tool is always in operating condition,
because it does not have to be plugged into an electrical outlet.
3. Always be sure you have firm footing.
4. Be sure no one is below when using the tool in high locations.
5. Hold the tool firmly and use both hands.
6. Keep hands and hair away from rotating parts.
7. Do not leave the tool running. Do not force tool to stay in the
"on" position. Operate the tool only when hand-held.
8. Do not touch the tool, accessory or the workpiece immediately
after operation; they may be extremely hot and could burn your
skin.
OPERATING INSTRUCTION
Installing Or Removing Battery Pack
1. Your new battery pack is not fully charged. You may need to
charge before use.
2. Make sure the tool forward/reverse lever is in the neutral
position when installing or removing a battery.
3. To remove a battery, depress the front tab and pull the
battery forward and the tool in the opposite direction.
4. For 14.4V and 18V batteries, slide the battery pack into the
charger as the arrow indicates. Push the battery pack into
place and make sure the red light on the charger is "ON".
The battery pack is now starting the charging cycle.
Charging The Battery Pack
Charging The Battery Pack
1. Battery may not charge when it is above a certain preset
temperature limit. Allow temperature of battery to cool before
charging.
2. The charge process will take less than one hour.
3. Remove the battery pack from tool or case and insert
terminals down into charger. The red light indicating that the
battery pack is charging will illuminate.
4. When the battery finishes charging the light will turn from red
to green. That means the battery pack is fully charged. The
green light will stay on until you remove the charged battery.
5. Unplug the charger from 12Vdc outlet.
MCL1840CHRG
MCL1840CHRG 14.4V-18V Battery Charger
Power On
(Green light flashes slowly)
Battery Low
(Red light stays illuminated)
Battery charged 80%
(Green light flashes rapidly)
Battery charged 100%
(Green light stays illuminated)
Battery Pack temperature is too hot
or too cold (Red light flashes slowly)
Battery Pack malfunction
(Red and Green lights stay
illuminated)
9. Some material contains chemicals which may be toxic. Take
caution to prevent working dust inhalation and skin contact.
Follow material supplier safety data.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Tool Operation
• Charger is plugged into a 12Vdc outlet only.
• If the battery pack is too hot or too cold, the charger will not
fast charge the battery and the red light will remain blinking.
When the battery temperature returns to a temperature
between 0-50 degrees Celsius. The charger will automatically
begin charging.
• If both red and green indicator lights are "ON" the battery
pack either does not comply or is defective.
• Any of the following conditions indicates damage to the
charger and/or battery pack. Please contact your distributor.
a) The charging light does not flash (green) when the
charger is plugged into a power source.
b) The charging light does not light up nor flash (red)
when the battery cartridge is inserted in the charger port.
c) Charging is not completed at even more than two
hours after red light comes ON at start of charging.
• Unplug the unit after the charging process and keep in a dry,
cool place.
3
rev. 09/1013
Publicité
