Klarstein TAP2GO Mode D'emploi page 16

EN
16
TROUBLESHOOTING
Problem
There's no beer coming
from the pump.
The beer foams too
strongly, too little liquid.
The beer flows too slowly.
Possible cause
Extension tube on the is
not well connected.
No keg in the system or no
beer in the keg.
The beer is not flowing
properly.
The temperature in the keg
is too high.
The keg was shaken
before use.
The beer in the barrel is
used up.
The pressure in the barrel
is too high.
The pressure in the barrel
is too low.
The extension pipe or the
gas pipe is leaking.
Suggested solution
Connect the extension
tube correctly.
Place a new keg in the
radiator.
Open the power take-off
lever completely. Find the
best distance between the
beer glass and the fitting
and hold the beer glass at
a slight angle.
Let the beer cool down
longer up to 3-6 °C.
Leave the keg to stand for
some time before using it.
Place a new keg in the
cooler.
Turn the knob clockwise to
turn the adjustable valve
down or off.
Check if the pipe is
damaged.