PCM KSE510 Mode D'emploi page 2

English
1. To fix the tool holder on the machine,
introduce the shank and use the pin for
positioning. Tighten the 4 fixing screws
(important, make sure that the screws
have the same clamping force).
2. Adjust the offsets of the 2 positions.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
KSE510
3. When mounting or dismounting of
cutting tools, spindle lock on the dishes
provided for this purpose, using an an
adapted wrench.
4. The
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
MARK :
empty positions. Use the supplied
protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
RBT
Validation : 28.01.2022
tool shank diameter should never
Never use the tool holder with
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email: office@pcm.ch
Document :
KSE510 1-. Mode
d'emploi.docx
Page : 2 de 4