Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
3
5
7
Remote control
Remote control
ON/OFF:
1
Press this button to turn on the unit. Press this
button again to turn off the unit.
MODE:
2
Each time you press the button, a mode is selec-
e t
d
n i
a
s
e
q
u
e
n
c
e
h t
t a
SAVE, FAN, and DRY, as shown below:
AUTO
COOL
-:
3
Press this button to decrease the set temperature.
Holding it down for more than 2 seconds will rapidly
decrease the set temperature. In AUTO mode, the
set temperature is not adjustable.
+:
4
Press this button to increase the set temperature.
Holding it down for more than 2 seconds will rapidly
increase the set temperature. In AUTO mode, the
set temperature is not adjustable.
FAN:
5
This button is used for setting the fan speed in the
sequence ranging from AUTO,
to
, then back to AUTO.
Auto
Speed 1
Speed 2
NOTE: Your AC model has three speeds.
Controls
2
4
6
8
g
o
e
s
f
o r
m
AUTO, COOL,
SAVE
FAN
DRY
.
,
,
Speed 3
Speed 4
I FEEL:
6
Press this button to activate the I FEEL function.
Under this function, the sensor in the remote controller
will send the temperature around the remote to the
unit every 10 min, and the unit will cycle to reach the
temperature sent by the remote. Press this button
again to turn off this function.
SLEEP:
7
Press this button to activate the Sleep mode. Within 2
hours after the Sleep mode is activated, the set
temperature will increase by 1℃/2℉ per hour. For the entire
night under Sleep mode, the set temperature increase
by 2℃/4℉. Press this button again to turn off the Sleep
mode. The Sleep mode is available in Cool, Energy Saving,
and Dry modes.
TIMER:
8
the unit
d H icon will be blin
to adjust the time
will increase or decrease the time by 0.5 h. Hold the + or -
button
for 2 seconds, to change increments faster. Release the
button after your required set time
the TIMER
blinking.
the unit
H icon will be blinking. Within 5 seconds, press the + or - button
to adjust the time
once will increase or decrease the time by 0.5 h. Hold the +
or - button
for 2 seconds, to change increments faster. Release
the button after your required set time
the TIMER
stop
blinking.
Cancel Timer On/Off: If the Timer
the TIMER button once to review the remaining time. Within
5 seconds, press the TIMER button again to cancel this
function.
Combination of the + and - buttons to lock/unlock
9
the remote control
Press the + and - buttons simultaneously to lock or unlock
the keypad. If the remote controller is locked,
point to
. In this case, if you press any button,
will blink three times.
Combination of the MODE and - buttons to alternate
10
between ºC / ºF
When the unit is OFF, press the MODE and - buttons simulta-
neously to switch between
Energy Saving mode
11
Under Energy Saving mode, both the temperature and
fan speed can be adjusted. The AC will cycle on and off
to maintain the temperature and fan speed you set.
16
Timer Off. The T-OFF
king. Within 5 seconds, press the + or - button
Timer Off
the + or - button once
The T-OFF
H icon will stop
Timer On. The T-ON
Timer On
the + or - button
The T-ON
and
.
H icon will
s set up, press
will
Publicité
Chapitres
Table des Matières
Dépannage
