NORDIK 15625026 Guide De L'utilisateur page 13

16. Slide the inner window sash firmly against the side
of the cabinet. Make sure not to peel the seal strips
from the window track and cabinet side channels. If
the panel frame does not fit snugly to the inner
window sash, secure the panel frame to the sash
with #8x3/4" screws or #8-32x3/4" self-
threading screws. Use the partially plugged holes in
the panel frame. Drill 1/8" pilot holes for the
screws.
17. Hook the safety bracket over the base of the
unit and fasten it to the front of the platform
assembly. Use a #8-32x3/4" self-threading
screw.
NOTE:
The bracket prevents movement of the
AC (either in or out) after completing the installation.
18. Stuff the foam seal strip/sash seal between
the vertical sash and the window glass, as shown
on the right.
19. Use the window locking bracket to lock the
inner window sash to the base of the outer window
sash. Use one #8x3/4" screw or #8-32x3/4"
self-threading screw. Drill a 1/8" pilot hole.
20. To replace the front panel
First reconnect the coupler plugs, then position the
exhaust control through the front in the proper
location. Gently push the front into position on the
cabinet. It should click into place. Then replace the
retaining screws that holds the panel in place.
Do not push or pull the front panel louvers.
Alternate window jamb
applications
To install your AC in windows having no
flanges or wood stops on the top and side jambs, the
channels and panel frame must fit against a mating
flange (or 1/16" max. thick angle) attached to the
window jambs. Figure A shows this angle installed.
Figures B & C show alternate treatments. On the sash
side of the opening, the leading corner of the inner sash
becomes the flange. You can purchase the angle
strip at your local hardware store.
Installation Instruction
11
Slide the inner
window sash
firmly against
the cabinet.
Install the safety bracket
Sash seal
Window
locking
bracket
Room
A
Add an angle to
the wood stop
Safety bracket
Flush
Room Room
C
B
Add a 16- or 18-
Add wood
gauge angle
as shown