Mocom Stillo Mode D'emploi page 21

,16758&7,216
$&7,9$7('
&+$5&2$/
,167$//$7,21
3285 :$7(5
,172 7+(
67$,1/(66
67((/ 7$1.
67$57,1* 83
6725( 7+(
',67,//('
:$7(5
6WLOOR
1. Turn the lid with the hole and separate it from the nozzle/square pouch
(Figure A).
2. Fold the activated charcoal sachet in half and put it into the nozzle and
reassemble the lid.
3. Put the lid with the hole on to the collection bottle, lining it up with the
spout on the distiller (Figure B)
☛
E
ACH ACTIVATED CHARCOAL SACHET CAN BE USED FOR UP TO A
).
MONTH
Lid
Nozzle
Figure A
Use hot/cold water to fill the tank and make sure that you do not go beyond
the full line. If you use hot water, you can shorten the time needed to distil
water.
Secure the upper cover and plug the power
cord into the socket on the body. Place the
collection bottle and the protective cover in a
secure place and make sure they are leveled.
Plug the power cord into the outlet and turn
on the power switch
☛
WHEN FIRST USED THE SWITCH IS
AUTOMATICALLY SET IN THE
,
POSITION SO THERE IS NO NEED TO
SWITCH IT ON FOR THE VERY FIRST USE
You will start the process when turn the
switch on and it will shut off automatically at
the end of the process. If you wish to terminate the process, unplug the
power line from the outlet. The power supply is turned off automatically
when distillation is completed. Approximately an hour after you have turned
on the power switch, the distilled water begins to drip down into the
collection bottle. It takes six hours to distil four litres of water. When the
power supply is cut off, you may move onto the next tank immediately.
For proper storage, place the distilled water into sealed containers and
store them in a cool and light-protected room.
Activated Charcoal
sachet
" "
ON
.
8VHU 0DQXDO
Figure B
Power cord
Power cord sochet
Body sochet
5