Fein GRIT GIM Notice D'utilisation page 11

3 94 10 014 000 - Buch Seite 11 Mittwoch, 16. August 2006 1:26 13
GIM
Adjusting the lowering/lifting force
(Figure 8).
The required lowering/lifting force can be
adjusted with the crank (23).
Adjust the lowering/lifting force in such a
manner that the belt grinder can be lowered
easily and is held automatically in the upper
position when tilting upward or during work
breaks.
Adjusting the parallelism (Figure 9).
For a uniform rate of removal, it is required that
the sanding/grinding belt runs parallel to the sur-
face.
Adjust the run of the belt with the star-knob
bolt (19).
Operating instructions.
Switch the machine on or off only via the
On/Off switch of the belt sander. The
"I" button on the electrical switchbox (18)
must always be pressed. The switch on the
electrical switchbox is only a safety switch
(emergency OFF pushbutton)!
Switching ON:
Release the safety switch (14) and fold it up.
Press the "I" (15) button.
Switching OFF:
Release the safety switch (14) and fold it up.
Press the "0" (15) button.
After switching off, the machine runs on
for approx. 50 seconds.
Safety switch (emergency OFF switch):
In emergency situations, press the red safety
switch (emergency OFF switch) (14) to
switch the machine off.
Working instructions
Move the wheeled carriage to the working
location.
Switch the belt grinder on and pull the han-
dle bar lever to the working position.
Move the belt grinder along the surface to be
ground with uniform speed.
After finishing the working procedure, tilt
the handle bar upward and switch the belt
grinder off.
Repair and customer service.
Repairs may be carried out only by quali-
fied persons in conformity with the valid
regulations.
For repairs, we recommend our FEIN customer
service centre, the FEIN authorised service cen-
tres and FEIN agencies.
Warranty and liability.
The warranty for the product is valid in accord-
ance with the legal regulations in the country
where it is marketed.
In addition, FEIN also provides a guarantee in
accordance with the FEIN manufacturer's guar-
antee. For further details on this, please contact
your specialist dealer, your national FEIN repre-
sentative, or the FEIN customer service centre.
Environmental protection, disposal.
Stationary machines should be sorted for envi-
ronment-friendly recycling in accordance with
national laws.
Specifications.
Type
Weight according to
EPTA-Procedure 01/2003
Class of protection
Connection diagrams.
Type GIM Appendix 60
EN
GIM
35 kg
I/
11