Publicité
Les langues disponibles
Les langues disponibles
ger (available as accessory at horizont) or by means of a plug-in power supply unit (also
available as accessory at horizont) on the rear side of the device.
Only use the original horizont accessories intended for this purpose to ensure a proper
charging of your warning light!
The use of power supply units and charging technology not approved by horizont group
gmbh constitutes improper use.
Switching the lamp ON
The lamp is activated by the membrane sealed rocker switch on front of the housing. Ori-
ent the lamp as exactly as possible towards the approaching traffic.
The switched-on luminaire communicates with other switched-on The activated lamp com-
municates with other active lamps of the same type via radio technology. Furthermore, it
can communicate with all other mobile LED sequential light systems as well as single lights
of the „horizont guiding light range", which are equipped with the horizont synchronisation
system and are located within radio range. Due to this feature, an auto-synchronisation
is realised resulting in a sequential running light system. The sequence is based on the
order in which the lamps are switched on. The synchronisation process is completed after
approx. 10-12 seconds. In order to change the sequence, all lamps must be switched off
and then switched on again in the desired sequence.
Use the black feet on the underside of the lamp to considerably increase the stability of the
lamp! Be sure to fold out the feet each time using the luminaire.
Switching the lamp OFF
The lamp is switched OFF by the membrane sealed rocker switch on front of the housing.
Storage
Always store the lamp with the feet folded in and the battery charged.
Optionally, horizont Euro-Blitz can also be mounted on traffic cones (size min. 750 mm)
by means of our horizont cone adapter for work sites of short duration. Both, cones and
adapters are available as horizontal accessories.
Assembly, maintenance, repair
There are no maintenance-relevant components / assemblies mounted within the
lamp. Do not open the housing except to insert or replace the accumulator.
The illuminant cannot be replaced.
The optics of the luminaire should be cleaned with water and a sponge after use.
The use of high-pressure cleaners, strong water blasts and chemical cleaning agents
should be avoided as this may cause water / chemicals penetrate into the housing.
Repair work should only be carried out by authorised specialists or by the manufac-
turer. This is the only way to ensure functional safety and thus the intended warning
effect in traffic.
Information for service and maintenance staff
It is important to avoid looking directly into the high-power LED when the product is swit-
ched on and the optics are removed, as this can cause eye irritation.
Disclaimern
The horizont group gmbh accepts no liability for personal injury or damage to property
resulting from improper use and/or improper installation, assembly, operation or
6
Publicité
