Cleaning And Maintenance - Dometic BUTTNER MT ICC Info Control Instructions De Montage Et De Service

ICC Info Control
If this mode, no icon will appear in the upper left corner of the display (fig. 2, page 4, 2). In the
upper right corner of the display (fig. 2, page 4, 4), the battery charge status is displayed.
A limitation of the AC input current needs to be set accordingly to the maximum allowed current
available from the RCD device at the camp site.
➤ To set the AC input current limitation, shortly press the rotary control knob (fig. 2, page 4, 5).
The permissible AC input current can be set between 1.0 A and 16.0 A in increments of 0.5 A.
I
NOTE
If the current selection switch on the inverter charger combination is set to 3 A or 6 A,
no change of the current value is possible with the rotary control knob. In this case, the
fixed value appears on the display.
8.8 Night mode
In the night mode, the maximum charging power is reduced by 50% and the fans are deactivated
for noiseless operation. The charger automatically quits the night mode after 10 hours.
➤ To activate the night mode of the inverter charger combination, press the On / Off / Mode but-
ton (fig. 2, page 4, 8) for more than 3 seconds.
The night mode is indicated with the moon symbol in the upper left corner of the display (fig. 2,
page 4, 2).
8.9 Economy mode
In economy mode, the battery charging and the inverter function is completely deactivated. Only
the mains transfer is active to pass external mains through to the existing sockets. This mode of
operation automatically ends after 10 hours.
➤ To activate the economy mode of the inverter charger combination, press the Backlight / Eco
button (fig. 2, page 4, 6) for more than 3 seconds.
The economy mode is indicated with the "ECO" symbol in the upper right corner of the display
(fig. 2, page 4, 4). In this mode, the Charger ON and Inverter ON LEDs are illuminated in red, while
the Line LED in green color on the control panel of the inverter charger combination.
9

Cleaning and maintenance

!
WARNING!
Unplug the device from the power supply before cleaning and maintenance
A
NOTICE! Damage hazard
• Never clean the device under running water or in dish water.
• Do not use sharp or hard objects, abrasive cleaning agents or bleach during clean-
ing as these can damage the device.
EN
Cleaning and maintenance
11