Legamaster STX Serie Manuel De L'utilisateur page 19

Network Configuration
Configure network settings.
Please refer to next page for more details.
Software Update (USB)
Update the firmware using USB drive.
Options: Yes, No;
Default: Yes.
Restore Factory Default
Restore all settings to their default.
Options: No, Yes;
Default: No
Network Configuration
OSD (ON-SCREEN DISPLAY) CONTROLS
Wake Up from Sleep
By default, the display will enter power saving
(Sleep Mode) if no signal is received for 5 minutes.
Normally, the RS-232, DisplayPort, and HDMI inputs
are inactive in Sleep Mode, to save power.
To change the behavior of Sleep Mode, change the
"Wake up from Sleep" setting in the "Adv. Setup"
menu.
I. VGA Only (default) – The RS-232, DisplayPort,
and HDMI inputs are inactive when the display is
in sleep mode. The display will wake up when it
receives a signal at the VGA input.
II. Digital, RS232C, Ethernet – The RS-232,
DisplayPort and HDMI inputs stay active when
the display is in sleep mode. The display will
wake up when it receives a signal at either of
the DisplayPort, HDMI, or RS-232 inputs, or via
LAN connection.
STX-SERIES – USER MANUAL – ENGLISH
19