Metabo HPT C3607DRA Instructions De Sécurité Et Mode D'emploi page 34

English
Fence
Ⓐ
Fence
Ⓑ
(3) Setting to cut crown moldings at positions 1 and 4
in Fig. 40 (see Fig. 45; tilt the head to the right):
1 Turn the turntable to the right and set the Miter Angle
as follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
3 Position the crown molding so that the upper surface
(Ⓑ in Fig. 39) contacts the fence as indicated Fig. 47.
Indicator
(For right bevel scale)
Base
Outside corner
34
Ⓑ
Table on base
Fig. 43
Ⓐ
Table on base
Fig. 44
35.3°
31.6°
30°
33.9°
Lower surface of
crown molding
Inside corner
Fig. 45
(4) Setting to cut crown moldings at positions 2 and 3
in Fig. 40 (see Fig. 46; tilt the head to the right):
1 Turn the turntable to the left and set the Miter Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
3 Position the crown molding so that the lower surface
(Ⓐ in Fig. 39) contacts the fence as in Fig. 48.
Indicator
(For right bevel scale)
Base
Outside corner
Fence
Ⓑ
Fence
Ⓐ
35.3°
31.6°
30°
33.9°
Upper surface of
crown molding
Inside corner
Fig. 46
Ⓐ
Table on base
Fig. 47
Ⓑ
Table on base
Fig. 48