Operating Your Blender - Jenn-Air JBL800 Mode D'emploi

Removing pitcher from base
1. Make sure the blender controls are set to "OFF"
and the power cord is unplugged.
2.Turn the pitcher counterclockwise and lift the
pitcher up and off the base.
3. Do not unscrew the base ring from the pitcher jar
until you are ready to remove the blade assembly.
Loosening it will cause leaking.
:
NOTE Be sure to operate your blender on a clean,
dry, sturdy surface.

Operating Your Blender

1. Make sure the touch controls are SET TO "OFF" and
the power cord is unplugged.
2. Place the assembled PITCHER ON TOP OF
BLENDER BASE and turn clockwise to lock the
pitcher in place.
3. LOAD BLENDER with food to be blended and place
the lid securely on the pitcher jar.
4.TOUCH THE "ON" PAD on the control panel.The
"ON" pad should illuminate and the WARNING light will flash to indicate that
the blender is ready to operate.
5.TOUCH ONE OF THE FIVE-SPEED PADS. Refer to the "Speed Control
Guide" in this manual for suggested settings. Refer to the "Pulse Mode" and
"Ice Crushing Mode" sections in this manual for use of those controls.
To avoid risk of injury, be sure that the blender is fully off with all control panel
lights off before opening the blender and scraping the sides of the pitcher. Never
attempt to scrape the sides of the pitcher while the blender is operating or with
any of the control panel lights illuminated.
WARNING
8
OFF
ON
MIX
CRUSH PULSE
I