Before You Call For Service - Jenn-Air JBL800 Mode D'emploi

Before You Call for Service

PROBLEM
The blender will
not start.
The blender is
spattering ingredients
outside the blender
pitcher jar.
The blender is leaking
around the bottom
of the pitcher.
The blender motor
is bogging down.
The blender wobbles
on the work surface.
POSSIBLE SOLUTION
• Check the power cord to make sure it is securely fas-
tened into the blender and into the electrical outlet.
• Make sure the "ON" pad is illuminated. Next, touch
the desired speed setting.
• Avoid touching two speed settings at once since this
will cause the blender to turn off.
• Make sure the pitcher lid is securely fastened into the
pitcher jar before blending.
• If the pitcher lid has been removed, make sure the
blender is set on a low setting to avoid spattering.
• The blender may be overloaded. Remove some of the
contents and continue blending.
• Make sure the pitcher gasket is positioned between the
pitcher jar and the blade base.
• Check to see if the base ring is securely screwed into
place and aligned evenly around the base of the
pitcher jar.
• Check to make sure the blender isn't overloaded with
dense foods. If so, break into smaller pieces.
• When using the ice "CRUSH" mode, be sure to use
solidly frozen ice cubes and break up any large chunks
of ice.
• Make sure the small pads on the feet of the blender are
all snugly pushed in.
• Check to see if the work surface is level.
13