Hozelock 2212 Mode D'emploi page 6

Note: To protect battery life the water controller can only be turned
on and off a maximum of 3 times in one minute.
How do I cancel an automatic watering operation
The button can also be used as a manual override to cancel
any current automatic watering operation that has started. The
schedule will then resume.
Battery level check
Press and hold down the Water Now
of the batteries at any time.
GREEN = BATTERY IS GOOD
RED = BATTERY LEVEL IS LOW, REPLACE THE BATTERIES SOON.
Failure prevention mode
A built in safety feature detects when the battery levels have
dropped to a level that could fail whilst the valve is open and result
in wasting water. The safety mode prevents the controller from
turning on until the batteries have been replaced. The LED indicator
light will flash red when the failure prevention mode has been
activated. The Water Now function will also not operate until the
batteries have been replaced.
This product is not designed to be used in sub-zero (frost)
temperatures. During winter months drain any remaining
water out of your timer and bring it indoors until the next
watering season.
6
button to check the status
Troubleshooting
Problem Possible cause
Valve opens but no Garden tap is off
water comes out
Hose pipe twisted or
blocked
Button pressed but Wrong or flat
valve doesn't open batteries
Button pressed 1 minute lock out
Light came on but has operated
valve did not open
Controller set up Controller waiting
correctly but did not to synchronise
come on at sunset
Controller activated Outside lights too
when outside lights bright
come on
Technical Data
Operating Pressure
Operating Temperature
Max. Water Temperature
Solution
Turn on tap
Untwist/unblock
hose hose
Check battery type
and/or replace with
fresh batteries
Wait three minutes
and try again
Wait 24hrs and
observe again
Move or rotate
controller away
from light sources
0.1 – 10 Bar
0 - 55°C
30°C