Maxtec Precision Medical R219P20 Mode D'emploi page 5

INSTRUCTIONS FOR USE
1. Attach the DISS female fitting A of the Blender Buddy to the DISS male fitting
on the left side of the Precision Medical
2. Attach flow meters C to the male DISS fittings D on the front of the Blender Buddy.
3. Supply gas to the blender and check for leaks and proper function.
Note: The blender buddy is designed for use on the primary port (left side) of a blender.
The blender buddy has a 3 lpm continuous bleed built into the manifold of the device.
When properly installed on the left side of a blender the blender buddy's bleed ensures
accuracy of flow from the primary port at low flow rates, i.e. less than 3 lpm and is equal
to the low flow accuracy of the auxiliary port on the right side of the blender.
E
B A
1
866.4.Maxtec
C
D
For use with the following models:
2
Precision Medical
Low Flow Blender(PM5300)
Blender E .
®
www.maxtec.com
C
®
B
3