Publicité
Les langues disponibles
Les langues disponibles
Installation Instruction
A: Remove the film from the bottom of the suction cup. Use a clean
cloth to clean your dashboard where you want do place the holder.
Do not use soap or chemicals.
Open the suction cup trigger (13), place the holder with a little
pressure on your dashboard and close the suction cup trigger (13).
Note: If the suction cup is dirty or dusty clean it with a little bit of
water by applying it with your finger. When the surface is try and
sticky again try again to attach the holder to your dashboard. Do not
use soap or chemicals.
If wanted it is also possible to attach the holder to the windshield,
then notice that the buttons and the display will be upside down.
Publicité
