Using The Chopper; Cleaning & Maintenance; Mounting - Inventum Silhouette MX 400 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5 | using the chopper
Warning: the blades of the chopper are extremely
sharp. Be careful while assembling, emptying the
chopper bowl and cleaning.
the chopper is suited for
chopping meat, cheese,
onions, herbs, garlic, carrots,
nuts, etc. attention: do not
chop any hard ingredients
such as ice cubes.
place the chopper bowl 7 on
a flat surface. place the knife
6 on the axle in the centre of
the bowl.
Pay attention - the
knives are extremely sharp.
place the ingredients in the bowl and place the lid
5. take the motor part 4 and attach it by turning it
clockwise on to the lid of the chopper.
7
press the turbo­switch 3 for maximum speed or press
the on­switch 2 to use the speed setting you have set on
top of the motor part with the knob 1 (variable speed
setting).
during processing, hold the motor part with one hand
and the chopper bowl with the other hand.
Attention: Do not activate the chopper constantly,
this can cause engine problems. Do not use the chopper
for more then 30 seconds continuously, wait 2 minutes
before you operate it again.
as soon as you release the switch (on or turbo), the
chopper will stop.
Wait until the knife stops turning
before you take the lid of.
the turbo­switch can also be used for instant power
pulses without having to set the speed.
always unplug the appliance from the supply if it is left
unattended and before assembling, disassembling and
during cleaning.
to remove the motor part after use, turn it anti
clockwise from the lid.
6
5
6 | cLeaning & maintenance
always unplug the appliance from the supply if it is left
unattended and before assembling, disassembling and
during cleaning. disassemble the motor part from the
accessory according to the instructions in the pictures.
• Wipe the motor part and the connector with a damp
cloth.
• rinse the lid of the chopper with water.
• do not use any abrasive or strong detergents. these
can damage the housing.
• never place the motor part, the power cable or the
plug in water or any other liquid.
• the accessoiries are dishwasher proof:
­ measuring beaker with anti­slip base/lid 9+10
­ blender shaft 8
­ whisk 12
­ chopper bowl 7
­ knife 6
be careful when cleaning the accessories by hand.
the knives of the blender shaft and the chopper are
extremely sharp.

7 | mounting

this stick mixer is supplied with a wall mount.
attach the bracket (I) with the enclosed screws to the
wall and slide the wall mount (II) over it.
now the wall mount is ready to hold the stick mixer.
18
II
I

Publicité

Table des Matières
loading

Table des Matières