Before First Use; Using The Stick Mixer; Using The Whisk - Inventum Silhouette MX 400 Mode D'emploi

2 | before first use
Before you use the appliance for the first time, please
do as follows: carefully unpack the appliance and all
the accessories and remove all the packaging material.
Warning: the blades of the blender shaft and the
chopper are extremely sharp. Keep the material (plastic
bags and cardboard) out of reach of children. check the
appliance after unpacking for any damage, possible from
transportation. rinse all the accessories with warm soapy
water and dry them thoroughly.
­ blender shaft 8
­ whisk 12
­ measuring beaker with anti­slip base/ lid 9+10
­ chopper bowl 7
­ lid for chopper 5
­ knife 6
Wipe the motor part and the connector with a damp
cloth. always roll out the cord completely. make sure
that all the parts are dry before you use the appliance.
3 | using the stick mixer
Warning: the blades of the blender shaft are
extremely sharp. take the
motor part 4 and the blender
shaft 8. attach the blender
shaft to the motor part by
turning the blender shaft
clockwise.
check that the knob for the
variable speed 1 is on the
lowest setting ­ o .
place the ingredients in the
measuring beaker 10. make
sure the measuring beaker is
not too full.
plug in the appliance. The
orange lighting around the
edge of the buttons light up.
press the turbo­switch 3 for
the maximum speed or press
the on­switch 2 to use the
speed setting you have set
on top of the motor part with
the knob (variable speed
setting).
as soon as you release the
switch (on or turbo), the stick mixer will stop.
max medium
When you have finished mixing or blending and released
the button wait until the knives have stopped turning,
before you approach the blender shaft.
the turbo­switch can also be used for instant power
pulses without having to set the speed.
Attention: Do not activate the stick mixer constantly,
this can cause engine problems. Do not use the stick
mixer for more then 45 seconds continuously, wait
until the engine is completely cooled down before you
operate it again. Blend larger quantities in multiples
sessions.
always unplug the appliance from the supply if it is left
unattended and before assembling, disassembling and
during cleaning.
to remove the blender shaft after use, turn it
anti clockwise from the motor part.
you can operate the stick mixer in the measuring beaker
and also in another bowl. When blending directly in a
saucepan while cooking, take the pan from the stove first
to protect the appliance from overheating.
the anti­slip base 9 is also an airtight lid.
4 | using the Whisk
use the whisk for example
for making whipped cream or
beating egg whites.
take the motor part 4, the
connector 11 and the whisk
12. attach the connector
to the whisk. attach the
complete whisk to the motor
part by turning the connector
clockwise.
check that the knob for the
variable speed 1 is on the
lowest setting ­ o. you will reach the best result.
place the ingredients in the measuring beaker 10. make
sure the measuring beaker is not too full (max. 400 ml.).
plug in the appliance. place the whisk in the measuring
beaker and press the on­switch 2 to use the speed
setting you have set on top of the motor part with the
knob (variable speed setting).
as soon as you release the on­switch, the whisk will stop.
always unplug the appliance from the supply if it is left
unattended and before assembling, disassembling and
during cleaning. to remove the whisk after use, turn it
anti clockwise from the motor part.
low
17
The orange lighting will extinguish.