Paradigm Reference OM-1000 Mode D'emploi page 5

Fig. 5a For Center Channels with Outrigger Feet
USE OF THIS TILT BRACKET IS RECOMMENDED, BUT OPTIONAL
Note: Bracket not for use with a Paradigm Stand
Fig. 5c Attaching the Tilt Bracket when the Center Channel is positioned
below a Television/Display – included on models with cradles only
STEP 1
Remove grille. To prevent scratching
the finish, carefully lay the speaker
on a blanket or soft drop cloth with
cradles positioned for easy access,
as shown.
STEP 2
Position bracket over cradle, as
shown. Align rear posts in bracket
with rear holes in cradle (see inset).
Press down firmly to engage posts.
Front posts will automatically align.
Fig. 5b For Center Channels with Cradles
STEP 3
Push down firmly with both thumbs
where indicated (see inset) and bracket
will snap into place. Repeat steps 1
to 3 for second bracket.
IMPORTANT! Should you wish to remove the tilt bracket at a later
date, you must unscrew the entire cradle/tilt bracket assembly. DO NOT
attempt to pry off the bracket as this will damage the cradle.
5