ARENDO 304972 Mode D'emploi page 34

• To drain excess water, place the appliance with the front side on an edge
and place a bucket underneath, or place the appliance over the sink. Now
pull out the drain plug on the bottom of the appliance. Caution! Please
note: Once the plug is removed, water flows out of the water tank!
• Remove the ice collector.
• Clean the inside of the appliance using a soft cloth dipped in warm water
and vinegar. Then rinse it with clean water and allow it to dry completely.
• Replace the drain plug in the correct position. Wash the ice collector in
warm, soapy water. Rinse and dry it afterwards.
• Clean the outside of the appliance with a soft, slightly moist cloth. Use a
mild dish washing detergent if necessary.
NOTE: Do not use any organic solvents, boiling water, cleaning agents, strong
acids and bases, etc., for cleaning.
• Please empty the water tank and dry it for storage if the ice maker is not
used for long durations.
8. Troubleshooting
PLEASE NOTE!
Error
" " LED
lights up
34
Cause
• Low water level
• Sensor is blocked
• Pump is faulty
Troubleshooting
• Fill the water tank
• Clean the sensor
• Please get in touch with our
Customer service depart-
ment
English