REV L2699 Instructions De Montage Et D'utilisation page 10

• Do not operate the product at, on or in the vicinity of open flames (e.g. candles)!
• Do not expose the product to direct sun and shield it from extreme heat!
• To avoid damage, do not bend or knot cables over sharp edges or corners!
SCOPE OF DELIVERY
Check the delivery for completeness and perfect condition.
In the case of missing parts or damage:
• do not mount the unit!
• do not put the unit into operation!
• make a complaint to the supplier.
The deliver consists of:
• Product
• Instructions
TECHNICAL DATA
• Output: 50W LED
• Illuminant: 288 LED´s
• Luminous flux: 5500lm
• Nominal values: 230V~; 50Hz
• Colour temperature: 6500K
• Colour rendering index (Ra/CRI): ≥ 80
• Energy efficiency class: A+
• LED service life: 25000h
• Beam angle: 360°
• IP protection class: IP20
• Protection class: I (S9)
• Ambient temperature: 0°C – 25°C / max. 25°C
• Supply line: 1.8m H05RN-F 3G1.0mm²
• Socket of the supply line: protection class IP44
FUNCTION
• Switch off the switch and turn the dimmer to „Off" before putting the luminaire into operation.
• Insert the plug into a 230V~ mains socket with a protective contact.
• Switch the switch on and turn the dimmer to the desired brightness.
• Turn the dimmer to „Off" and turn the switch off when you no longer need the luminaire.
Note: If you only turn the dimmer to „Off" but leave the switch on, the luminaire will continue to consume electricity.
• For installation/application options, see A2
CLEANING
• Disconnect the product from the power supply and secure the circuit from being switched on again.
• Allow the luminaire to cool down sufficiently!
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
• Never spray for cleaning or use a steam pressure cleaner, as this may damage the insulation and seals!
MAINTENANCE
• Remove all dirt from the housing or protective panel immediately, as this can lead to overheating.
• The light source of this luminaire is not replaceable; if the light source has reached the end of its service life, the
entire luminaire must be replaced.
GB
10