Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL CONNECTION
Before plugging the appliance into the mains socket, check that the mains power supply corre-
sponds to the value indicated on the rating plate.
Installation
The appliance can be used on any rigid horizontal surface.
OPERATION AND USE
1. Plug the appliance into an appropriate outlet.
2. The appliance will emit a "beep" and the ON light will come on. It will remain lit as long as
there is power to the appliance.
3. Press button (G) to turn the appliance on.
4. The appliance starts up in LOW mode (minimum heat output). The display shows the current
room temperature.
5. Press the MODE button (F) to switch to HIGH mode (maximum heat output). The display
shows the current room temperature.
6. Press the MODE button (F) again to switch the appliance to AUTO mode.
The display shows the temperature set point. Use the + and - buttons to set a different tem-
perature. After a few seconds, room temperature is shown on the display.
7. Press the MODE button (F) again to switch the appliance back to LOW mode.
When the MODE button is pressed continuously, the appliance switches through the fol-
lowing modes in sequence: LOW
8. To turn the appliance off, hold button (G) down for a few seconds.
MOTORIZED ROTATING BASE
The appliance has a motorized rotating base to distribute the air flow over a larger area. To
activate the motorized base press the swing switch (C). The appliance swings from right to left.
To stop the appliance in the desired position, simply press button (C).
To turn the appliance off, hold button (G) down for a few seconds.
Adjusting the thermostat
1. Press the MODE button (F) until AUTO is displayed.
2. Use the + and - buttons to increase or reduce the temperature set point. The thermostat will
automatically maintain the temperature set and keep it constant.
3. When room temperature is 2°C above the set temperature, the appliance goes off. The
internal fan will stop after 15 seconds.
4. When room temperature drops below the set temperature, the appliance comes on automa-
tically.
Note: if swing mode is active, press buttons to change the set temperature, the swinging of the
base will stop to allow a new temperature to be set. After the setting procedure has been com-
pleted, the swinging of the base will resume automatically.
Timer function
This function can be activated during any operating mode. The timer can be used to program
the time the appliance remains in operation, from 1 to 8 hours.
Each time you press the button (F), the operating time increases by one hour.
When the timer has been set, the time decreases in steps of one hour and the time remaining is
displayed. At the end of the set time the appliance goes off.
If you do not want to use the appliance with the timer, press the button (F) again to return to
manual operation. The words "8 h" will be displayed.
Note: The display shows room temperature in either °C or °F. To select, press the + and - but-
tons together for a few seconds, then release.
4
All manuals and user guides at all-guides.com
HIGH
AUTO.
Publicité
