Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION AND POWER
SUPPLY
CAUTION:
● Be careful not to pinch your fingers when opening
and closing the battery cover.
● Return the battery compartment locker to the
original position, after installing or removing
battery cartridge. If not, battery cartridge may
accidentally fall out of the radio, causing injury to
you or someone around you.
● Always close and lock the battery compartment
locker before moving the radio.
● Always switch off the radio before installing or
removing the battery cartridge.
● Be careful not to drop or strike the radio. Broken
shell may slash your finger or stab your body.
Damaged radio may exhibit unpredictable
behaviour resulting in fire, explosion or risk of
injury.
● Hold the tool and the battery cartridge firmly when
installing or removing battery cartridge.
IMPORTANT:
● Reduced power, distortion and a "stuttering sound" or
low battery sign
the signs that the main battery pack needs to replace.
● When low battery sign
on flashing is the time to replace the backup batteries.
● The battery cartridge can't be charged via the supplied
AC power adapter.
● The battery cartridge is not included as standard
accessories.
Installing or removing slide battery
cartridge (Fig. 2-5)
● To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click.
● If you can see the red indicator on the upper side of the
button, it is not locked completely. Install it fully until the
red indicator cannot be seen. If not, it may accidentally
fall out of the radio, causing injury to you or someone
around you.
● Do not use force when installing the battery cartridge.
If the cartridge does not slide in easily, it is not being
inserted correctly.
● To remove the battery cartridge, slide it from the radio
while sliding the button on the front of the cartridge.
that appears on the display are all
appears and an "E" keeps
Indicating the remaining battery capacity
(Fig. 6-8)
1. Indicator lamps
Press the check button on the battery cartridge to indicate
the remaining battery capacity. The indicator lamps light
up for few seconds.
Indicator or lamps
Lighted
(For XGT and LXT battery cartridges
(For XGT and LXT battery cartridges
NOTE:
● Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from the
actual capacity.
● The first (far left) indicator lamp will blink when the
battery protection system works.
Back up battery Installation (Fig. 9)
Keeping back up batteries inside the compartment prevent
stored data in preset memories from being lost.
1. Pull out the battery compartment locker to release
battery compartment. There are main battery pack
compartment and back up battery compartment.
2. Remove back up battery compartment cover and insert
2 fresh UM-3 (AA sizes). Make sure the batteries are
with correct polarity as shown inside the compartment.
Replace the battery cover.
3. After back up batteries are inserted, insert the main
battery pack to power radio.
Using supplied AC power adapter
Remove the rubber protector and insert the adapter
plug into the DC socket on the right hand side of the
radio. Plug the adapter into a standard mains socket
9 ENGLISH
2. Check button
Off
Blinking
only)
only)
Remaining
capacity
75% ~ 100%
50% ~ 75%
25% ~ 50%
0% ~ 25%
Charge the
battery.
The battery
may have
malfunctioned.
Publicité
