ELV Electronik WS 250 Edition Notice D'emploi page 56

• Insert the rainfall sensor into its holder. It will hold
the count rocker firmly automatically.
Only one orientation is correct; the cable
of the rainfall sensor and the magnet of
the count rocker have to be on the same
side; the plastic nib on the other side has
to be inserted precisely into the holder,
look at the circle in the picture on the right.
• Place the cone collector from the top onto the sensor carrier and snap it in by turning it to the
left.
• Push the lower part of the rain gauge housing upwards and lock it by turning it to the right until
it snaps in.
The drain holes in the lower part of the housing have to point to the outside so that
the water does not run on to the metal stands.
56