Swisher E4-U3000 Manuel D'utilisation page 6

Assembly (continued)
Installing a Tool Attachment
1. Place the unit and tool assembly on a
clean, flat surface so that both assem-
blies fit end to end. The unit should be
facing up and the tool assembly should
be positioned with the locking hole in
the tube end facing up.
2. Slip off the protective covers from the
ends of both tubes, and loosen the cou-
pler screw knob.
CAUTION!
Keep the open ends of the tubes clean
and free of impurities!
3. Insert the upper tube assembly into the
coupler, with the tool decal facing up,
until the line of the decal is flush with
the end of the coupler.
4. Twist the tool back and forth until you
are sure it snaps in place by the coupler
latch.
5. When the two tube halves are locked
together, press down on the spring-
loaded latch protector and tighten the
coupler screw.
Removing a Tool Attachment
1. With the unit on a clean, flat surface,
loosen the coupler screw. The spring-
loaded coupler protector should pop up.
2. Press down on the latch with your fin-
ger or thumb. This releases the coupler
lock.
3. Pull the tool assembly out of the coupler.
6
Latch Protector
(extended)
Outer tube
Coupler Screw Knob
Coupler
Coupler Screw Knob
Latch
Locking Hole
Coupler
Latch Protector (lowered)
Press
Latch
Tool Assembly