Operation - Swisher E4-U3000 Manuel D'utilisation

Operation

Checking Unit Condition
NEVER operate the unit with the cut-
ting attachment shield or other protec-
tive devices removed!
Use only authorized Swisher parts and
accessories with your Swisher trimmer. Do
not make modifications to this unit without
written approval from Swisher, Inc.
ALWAYS make sure the cutting attach-
ment is properly installed and firmly
tightened before operation.
NEVER use a cracked or warped
cutting attachment: replace it with a
ser viceable one.
Shoulder strap
NOTE:
Although a shoulder strap accessory is
not required for use with a grass trimmer,
a shoulder strap can increase opera-
tor comfort during extended periods of
operation.
10
ALWAYS make sure the cutting attach-
ment fits properly into the appropriate
attachment holder. If a properly installed
attachment vibrates, replace the attach-
ment with new one and re-check.
ALWAYS stop the engine immediately
and check for damage if you strike a
foreign object or if the unit becomes
tangled. Do not operate with broken or
damaged equipment.
NEVER allow the engine to run at high
RPM without a load. Doing so could dam-
age the engine.
NEVER operate a unit with worn or dam-
aged fasteners or attachment holders.
WARNING!
A cutting attachment shield or
other protective device is no guarantee
of protection against ricochet. YOU
MUST ALWAYS GUARD AGAINST
FLYING DEBRIS!
IMPORTANT!
Adjust the shoulder strap so the shoulder
pad rests comfortably on the off-side
shoulder and the cutting path of the cut-
ting attachment is parallel to the ground.
Make sure all hooks and adjustment
devices are secure.