LaTrax TETON Guide De Démarrage Rapide page 8

TURNING ON YOUR MODEL
1
1. Turn on the transmitter. Always turn the transmitter on first, before turning on the model.
The transmitter's LED will glow.
2. Plug the battery into the speed control. Make certain the plugs are fully engaged.
3. Turn on the model. Press and release the EZ-Set button on the speed control.
The LED will glow red.
Note: If the LED is not red, see the Owner's Manual at LaTrax.com for more information or contact LaTrax Customer Service.
BEFORE OPERATING YOUR MODEL
Check servo operation
Confirm the model's wheels turn right and left when the
transmitter steering wheel is turned right and left. The
front wheels should be pointing straight ahead. If they
are turned slightly, slowly adjust the steering trim knob
on the transmitter until they are pointing straight ahead.
Range test the radio system
With a friend's help, check servo operation at the
farthest distance you plan to drive the model and
confirm that there is no radio interference.
OPERATING YOUR MODEL
Avoid running your model in tall grass, deep sand, or other
conditions that severely limit the driving performance of the
model. This will strain the power system and could cause
early motor failure. If the model becomes stuck, do not
apply throttle. Free the model before continuing.
The transmitter has a directional antenna. For maximum
range, hold the transmitter upright and pointed in the
direction of the model. Pointing the transmitter away
from the model will reduce radio range.
AFTER YOU RUN YOUR MODEL
1
1. Turn the model off. Press and release the EZ-Set button on the speed control.
The speed control's LED will go out.
2. Unplug the battery and remove it from the model. Do not store the model with
the battery installed.
3. Turn the transmitter off. Always turn the transmitter off last, after the model has been
turned off.
8
2
2
3
Steering
Trim
Note: After stopping the model, return the
transmitter's trigger to neutral and push
forward to activate reverse throttle.
3
Set Button
Brake/
Forward
Reverse
Neutral