Polaris Vac-Sweep 180 Manuel Du Propriétaire page 6

Masquer les pouces Voir aussi pour Vac-Sweep 180:

Les langues disponibles

Fine Tuning The Polaris Cleaner

When operating correctly, the Polaris 180 vacuums, sweeps and scrubs all surfaces

randomly throughout the pool. The climbing ability of the Polaris depends on the pool's

shape and water pressure or flow. The Polaris climbs best in pools without sharp angles

or curves in the transition from the pool floor to the pool wall.

Approximately every 3 minutes the Polaris 180 goes into back-up mode. This action pulls

the Polaris away from pool obstacles and increases its random pattern.

Thrust Jet Adjustment

The thrust jet powers the direction of the Polaris.

Factory position is straight back, but depending on the

pool, other settings are helpful.

Sweep Hose Adjustment

The sweep hose should move in a gentle sweeping

motion. To increase or decrease its motion, turn off the

booster pump and turn the sweep hose adjustment screw.

See Troubleshooting for other action adjustments.

Routine Maintenance

Cleaning the Filter Bag

Remove the bag from the cleaner. Open the bag closure and dump out the debris.

Backwashing the Pool Filter

Always disconnect the Polaris from the pool wall before cleaning or backwashing the pool

filter. After cleaning or backwashing, let the filtration system run for at least five minutes

to flush out the return lines before re-connecting the Polaris.

Storage and Winterizing

Never store the Polaris in direct sunlight. When storing for the winter, drain out all the

water (freeze damage is not covered under the warranty). Remove the UWF from the

pool wall by attaching the Quick Disconnect and using pulling pressure to unscrew. In

some cases, it may be necessary to use the UWF Removal Tool (part #10-102-00)

available from an authorized Polaris dealer.

Velcro

Closure

For on-line support: www.polarispool.com

Whenever possible, empty the

filter bag when it is half full,

especially if the dirt load is sand.

It is easier to empty the filter bag

when it is dry. Alternate between

two filter bags. When one

becomes full, remove it and put

on the clean bag.