IP CLEANING PROMAC VAC 27T Manuel D'instructions page 6

GB
DESCRIPTION AND ASSEMBLY
A - Motor block.
B - Switch.
C - Float: its purpose is to avoid that liquid may goes
inside motor block during suction.
D - Polyester filter to set into the tank to pick up dust,
and to remove for liquid suction.
E - Hooks for tightening of motor block to tank.
F - Suction inlet.
G - Tank.
H - Flexible hose.
I - Tube.
L - Wet tool.
M - Round brush.
N - Flat lance.
P - Small brush.
Q - Aspirmatic double use brush.
R - Wand.
ATTENTION: In order to keep in good efficiency the machine it is
useful to clean the polyester filter after each utilization.
INDICATIONS TO BE SCRUPULOUSLY ADHERED TO
• This apparatus is not to be used by people (children included) with
reduced physical, sensorial or mental capacities or without any
experience and knowledge, unless they did not receive instructions
relative to the use of the apparatus and are controlled by a person
responsible for their safety.
• Children should be controlled so that they didn't play with the
apparatus.
• The packaging components could constitute potential dangers (as
for example plastic bags): they must be kept away from children' s
reach and from other people not conscious of their actions.
• Any different use from that indicated in this manual could constitute
a danger, therefore, it must be avoided.
• Every part of the apparatus must be correctly assembled before
using it. Verify, furthermore, that the filtering elements (as for
example paper bag, filter cartridge, etc.) have been correctly and
efficiently assembled.
• Ensure that the socket conforms to the apparatus' plug.
• Ensure that the voltage indicated on the motor block corresponds
with the power that is intended to connect the apparatus to.
• Avoid positioning the suction aperture next to delicate parts of
the body such as eyes, mouth, ears, etc., while the apparatus is
functioning.
• Ensure that the floater, that has the function to stop the suction
when the keg is completely filled with liquid or in case of tipping
over, does not show any damages or clogging that might prevent
the suction. Regularly clean the floater (water level limiting device)
according to the instructions and control for any damage signs.
• ATTENTION this apparatus is not suited to pick up dangerous
dust.
• ATTENTION: do not suck inflammable substances (ashes from
fire-place), explosive, toxics or dangerous to the health.
• ATTENTION: the apparatus is not suitable for areas protected
against electrostatic discharges.
•. ATTENTION: use only the brushes supplied with the apparatus
or those specified in the instruction manual. Using other brushes
could jeopardize safety.
NOISE LEVEL: Values measured according to EN 60704 - 1 (1997) / EN 60704 -2 - 1 (2001) rules. Measurement A for the sound pressure
level of the machine is 73,4 dB (A) Under unfavourable feed conditions, the appliance may cause temporary drops in voltage.
6
OPERATING INSTRUCTION
- Insert the polyester filter in the tank (Fig. 1).
- Assembly the head on tank and block it by hooks (Fig. 3)
- Connect the flexible hose into the inlet (Fig. 4).
- Connect the wand and the extensions to other side of
flexible hose (Fig. 5).
- Select the most suitable accessory (Fig. 6).
- Connect the plug to power socket then switch on the
equipment (Fig. 7).
- Example of use of flat lance (Fig. 8).
- Example of use of small tool (Fig. 9).
- Example of use of brush on the floor (Fig. 11).
- Example of use of brush on the carpet (Fig. 12).
- Example of use of round brush (Fig. 10).
LIQUID SUCTION / OPERATING INSTRUCTION
- Remove the polyester filter bag (Fig. 2).
- Assembly the head on tank and block it by hooks (Fig. 3)
- Connect the flexible hose to the inlet (Fig. 4).
- Connect the extension to other side of flexible hose (Fig. 5)
- Connect the wet tool (Fig. 6).
- Connect the plug to power socket then switch on the
equipment (Fig.7)
- Example of use of wet tool (Fig. 13).
• ATTENTION: don't leave the apparatus unattended while is in
function.
• ATTENTION: in case o foam or liquid discharge switch off
immediately.
• ATTENTION: in case tipping over, lift the apparatus before switching
off.
• Do not aspire water from containers, sinks, basins, etc.
• Do not aspire aggressive detergents because they could damage
the apparatus.
• Do not aspire materials that could damage the filtering elements
(such as glass, metal etc.).
• Do not ever pull or lift the apparatus through the electrical
cable.
• Do not immerge the apparatus into water and neither use water
jets to clean it
• Always remove the plug from the current socket before undertaking
any type of intervention on the apparatus or if it is left unattended
or within children or people' s reach not quite conscious of their
own actions.
• Regularly control the feeding cable looking for damages, cracks
or ageing. Substitute the cable before using it further.
• If the feeding cable is damaged it must be substituted by the
manufacturer or by its after sales service or in any case by a
similarly qualified person, thus preventing any possible risk.
• When using extension electric wires ensure that they are lying
on dry surfaces and protected against possible water jets.
• Specialized personnel must always carry out maintenance and
repairs; any damaged part must be substituted with original spare
parts.
• ATTENTION: it is forbidden to carry out changes to the apparatus.
Tampering could cause fires and damages even lethal to the user
and the forfeiture of the guarantee.
• The manufacturer declines any responsibility for damages caused
to people or things due to non-compliance with these instructions
or if the apparatus is unreasonably used.