Black Max BM08570 Manuel De L'opérateur page 9

WARNING:
Disconnect the spark plug wire before assembling parts.
Failure to do so could result in possible serious personal
injury.
ASSEMbLING THE bLOWER TUbES
See Figures 2 - 4.
 Place a tube clamp on blower past the raised tabs.
Assemble the elbow tube onto blower by aligning raised
tabs on blower with slots on elbow. Tighten tube clamp
onto elbow.
 Attach bellows onto elbow tube by placing a tube clamp
on one end of the bellows then press bellows onto elbow
tube. Tighten tube clamp.
 Place a tube clamp on other end of bellows. Press bellows
onto throttle control handle tube. Tighten tube clamp.
NOTE: The position of the throttle control handle may be
adjusted for comfort after the blower is strapped onto the
operator's back.
 Join the straight tube and nozzle together by aligning
raised locking tabs on straight tube with the raised locking
slots on nozzle and twist to secure.
 Assemble the connected lower tubes to the throttle
control handle tube by aligning raised locking tabs on
the throttle control handle tube with the raised locking
slots on connected lower tubes by twisting to secure.
NOTE: Check all locking connections after initial run to
ensure they are tightly secured.
 Hold the throttle cable against the bellows and install the
cable ties. Cable ties should be tight enough to retain
the throttle cable to the bellows but still allow for move-
ment.
All manuals and user guides at all-guides.com
ASSEMbLy
ADjUSTING HARNESS AND WAIST STRAPS
Straps should be adjusted to a comfortable position before
starting the blower.
To adjust harness strap assembly:
 Blower should be in operating position before adjusting
 There are three possible height adjustment positions that
 Slip top buckle of harness from adjustment slot and
 Tighten (pull down on strap) or loosen (lift up on tab of
 Chest strap should be tightened or loosened until adjusted
To adjust waist strap assembly:
 Waist strap should be tightened or loosened until adjusted
ADjUSTING THROTTLE CONTROL HANDLE
See Figure 5.
 Loosen throttle control handle locking screw by twisting
 Move throttle control handle to desired position and
Page 7 — English
CAUTION:
Make all adjustments to the harness straps before start-
ing the blower to avoid the possibility of injury.
the harness straps. Slip arm through harness strap and
onto shoulder, then repeat for the other shoulder.
can be used to easily adjust harness.
position to desired height location.
strap buckle) each harness strap as needed, until each
is adjusted to a comfortable operating position.
to a comfortable operating position.
to a comfortable operating position.
counterclockwise.
secure locking screw by twisting clockwise.