Safety information
GENERAL SAFETY (Continued)
WarninG
risk of personal injury. Never
operate compressor without a
beltguard. This unit can start
automatically without warning.
Personal injury or property
damage could occur from contact
with moving parts.
WarninG
risk of personal injury. This
compressor is extremely top
heavy. The unit must be bolted to
the floor with isolation pads before
operating to prevent equipment
damage, injury or death.
Caution
risk of personal injury.
Compressor parts may be hot
even if the unit is stopped.
SPRAYING PRECAUTIoNS
1. Do not smoke when spraying paint, insecticides, or other flammable substances.
2. Use a face mask/respirator when spraying and spray in a well-ventilated area to prevent health
and fire hazards.
3. Do not direct paint or other sprayed material at the compressor. Locate compressor as far away
from the spraying area as possible to minimize overspray accumulation on the compressor.
4. When spraying or cleaning with solvents or toxic chemicals, follow the instructions provided by
the chemical manufacturer.
WarninG
risk of fire. Do not spray
flammable materials in vicinity
of open flame or near ignition
sources including the compressor
unit.
WarninG
risk of explosion. An ASME code safety
relief valve with a setting no higher than
the maximum allowable working pressure
(MAWP) MUST be installed in the tank for
this compressor. The ASME safety valve must
have sufficient flow and pressure ratings to
protect the pressurized components from
bursting.
Caution
Do not overpressure. See compressor
specification decal for maximum operating
pressure. Do not operate with pressure switch
or pilot valves set higher than the maximum
operating pressure.
notiCe
unit Care and maintenance. Drain liquid from
tank daily.
5