Explanation Of The Symbols; Multi-Tool Safety - Batavia BT-CMT003 Mode D'emploi

English
Dear customer
Please familiarize yourself with the proper
usage of the device by reading and follow-
ing each chapter of this manual, in the order
presented. Keep these operating instruc-
tions for further reference.
Please read the enclosed "General safety
instructions for power tools" and all
additional safety instructions in this
operating instructions!
This manual contains important informa-
tion on operating and handling the device.
Keep these operating instructions for fur-
ther reference. Please pass it on along with
the unit if it is handed over to a third party.
Battery and charger not included!
The Maxxpack batteries and chargers are
available online and in participating stores.

1. Explanation of the symbols

Warning! To reduce the risk of
injury, the user must read the
instruction manual.
Denotes risk of personal injury, loss
of life or damage to the tool in case
of non-observance of the
instructions in this manual.
Always wear hearing protection.
The effects of noise can cause
hearing loss.
Wear safety glasses. When working
with electric power tools, sparks,
splinters, chips and dust particles
may be generated and these can
cause loss of sight.
Electric power tool, protection
class II. This sign symbolises that
this unit corresponds to Protection
Class II. This means that the unit is
equipped with either reinforced or
double insulation between the
mains circuit and output voltage or
metal housing respectively.
CE stands for "Conformité
Européenne", which means "In
accordance with EU Regulations".
With the CE marking, the
manufacturer confirms that this
Electric tool complies with the
applicable European directives.
4
Do not dispose of electric power
tools with domestic refuse.

2. Multi-Tool Safety

General safety advice for multi-purpose
hand-held cordless and corded tools includ-
ing both rotating and oscillating types.
WARNING: Contact with electric or gas
lines can lead to fire, electric shock and
explosions. Penetrating a water line can
result in damage to property and electric
shock. Use appropriate detectors to deter-
mine if utility lines are hidden in the work
area. Always be extremely careful when
making blind and pocket cuts where the exit
point of the blade or accessory at the other
side of the material cannot be seen.
WARNING: Asbestos may be in materials
and textured coatings in older properties
and should be treated with extreme caution.
If you suspect or discover asbestos consult
your local health and safety authority imme-
diately for advice on its removal. It may
require the services of a specialist asbestos
removal company.
WARNING: If a cutting accessory makes
contact with a 'live' wire, the exposed metal
parts of the power tool may become 'live'
and could give the operator an electric
shock. Hold the power tool by the insulated
gripping surfaces at all times during use.
WARNING: DO NOT work with damp or wet
materials or accessories that require liquid
coolants. Liquids entering the body of the
tool is an electrical hazard as well as likely
to destroy the tool.
WARNING: The dust produced from work-
ing with some materials can be toxic.
Beech, oak, mahogany and teak natural
woods, man-made composite woods and
some surface treatments including paint
with lead are toxic. Lead-based paint is
common in buildings pre-1960. Always wear
suitable respiratory protection, for example,
a respirator face mask. Ideally also use a
dust-extraction system or regularly vacuum
the work area to prevent the build-up of dust
and do a final vacuum after the work is
completed. Most dust is a fire hazard. Over-