Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Identify your type
hob by comparing the number and
layout of the burners on your appliance
with the illustrations (0.1.1), (0.1.2),
(0.1.3) et (0.1.4).
Make a note of the references of your
appliance on the "After-Sales Service
and Customer Relations" page so that
you can readily find them in future
(6.1.1). This page also explains where
to find them on your appliance.
1.1 – FITTING :
This worktop must be at least 3 cm
thick and heatresistant or else coated
with a heat resistant material.
If a horizontal partition is installed
under the hob, it must be positioned
between 10 and 15 cm below the
worktop.
Under no circumstances keep any
sprays or pressurised containers in any
compartment below the hob (see
"Safety guidelines" chapter).
Follow the guidelines in the sketch
(1.1.1).
Remove the "pan supports", burner
o
caps and burner heads, noting their
original positions.
Turn the hob upside down and
o
place it carefully over the top of the
base unit, so as not to damage the
knobs or igniters.
To ensure a good seal between the
o
body of the hob and the worktop, stick
the foam seal
the body, before installing the hob
(1.1.4).
a
c
b
d
around the edge of
of
Place the hob over the opening in the
base unit, taking care to pull the hob
towards you.
Fit the burner heads, caps and pan
supports.
Connect your hob to the gas (see "Gas
connection"
electricity (see "Electrical connection"
section).
If you wish,
you can secure the hob in position,
using the two fixing clamps
screws supplied supplied (1.1.5) fixing
them to the two corners of the housing.
It is essential that you use the holes
provided for the purpose, as per the
drawing (1.1.3).
Stop screwing when the clamp
starts to bend.
Do not use a power screwdriver.
23
section)
and
to
the
and
Publicité
Chapitres
Table des Matières
