Blue Hawk YTL22111-4 Mode D'emploi page 5

ASSEMBLY INSTRUCTIONS
1. Attach the tongue support (D) and clamp plate (E)
to the poly bed (C) using eight sets of M6x16 screws
(GG), Ø6 lock washers (MM) and M6 hex nuts (JJ).
Note: The hole on tongue support (D) should be on
right side.
Hardware Used
GG M6x16 Screw
Ø6 Lock Washer
MM
JJ M6 Hex Nut
2. Attach the wheel axle supports (B) to the back of
poly bed (C) using eight sets of M8x16 screws (FF),
Ø8 lock washers (NN) and M8 hex nuts (II).
Hardware Used
FF
M8x16 Screw
NN
Ø8 Lock Washer
II
M8 Hex Nut
3.
Center the hitch tongue (I) in the wheel axle support (B).
Insert the wheel axle (A) through the hole and slide
it through both the wheel axle support (B) and the
hitch tongue (I).
1
x 8
x 8
x 8
2
x 8
x 8
x 8
3
EE NN
5
II NN
B
C
FF
B
A
B
A
H
G
Lowes.com
MM JJ
D
E
C
GG
I
I
F