Sonos Digital Music System Guide D'installation page 8

Sonos Digital Music System Setup Guide
2
Connect First ZonePlayer
Note: The first ZonePlayer you install must connect to your home network using a
standard Ethernet cable (supplied). If your computer only has a wireless connection,
go to http://faq.sonos.com/wireless for assistance.
Connect a standard Ethernet cable (supplied) from any of the four (4) Ethernet switch connectors
on the back of your ZonePlayer to an open port on your router (see A in the diagram below). Do
not connect the ZonePlayer directly to your cable or DSL modem unless your modem has a built-
in router.
• If you don't have a router, go to http://faq.sonos.com/norouter for instructions.
• If you don't have an open port on your router, you can disconnect your computer from
the router and connect it to the ZonePlayer instead. Then connect the ZonePlayer into
the router port the computer was previously plugged into.
All manuals and user guides at all-guides.com
5
If you have
structured (built-in)
wiring, connect the
Ethernet cable into a
live wall plate (see B
in the diagram).
If your router has only 1
port or no unused
ports, go to
http://faq.sonos.com/
norouterport for
additional information.