winefit CUBO Mode D'emploi page 40

OK!
 Slide the inner collar
up until the striker
edge comes into
contact with the
lower edge of the
drip bead. Screw
the outer collar onto
the inner collar until
both collars are
firmly locked
underneath the
bead and cannot
move either
downward or upward.
40 -
ENGLISH
NO!
 Place the inner collar on the neck of the wine
OK!
 While holding the inner collar or both collars in place,
insert the assembled dispenser cap and screw down.
NOTE: for correct tightening, the cap must be
screwed on while the inner collar or both collars are
held firmly in place.
 To check correct tightening, hold the dispenser
bottle, checking that the striker edge is below the
drip bead.
NO!
cap and attempt to rotate the bottle. The bottle
should not turn; if it does, tighten the dispenser
cap slightly on the collars as explained above.
40
NO!