Maintenance; Cleaning - Cuda surgical LIT-171 Mode D'emploi

3. ASSEMBLING THE HEADLIGHT SYSTEM
Before continuing remove the protective lens cap.
To attach the power cable to the Battery Holster, insert the push/pull quick connector into
the mating power receptacle located next to the On/Off rotary-switch located at the base of
the battery holster. Align the four connector pins and push straight in until it clicks into
position.
The On/Off switch is also the LED intensity control. Simply rotate the knob clockwise or
counter-clockwise to produce the desired light output.
The 8500 Series LED Headlights has an iris to allow adjustment of the beam spot
diameter. Rotate the fluted iris adjustment ring on the headlight clockwise or
counterclockwise for the appropriate spot diameter.
The battery holster is worn on a belt; on the rear side of the holster is a metal belt clip that
slips over and secures to a belt. The power cable secures into the cable clips on the side
and rear of the headband.
To remove the power cable from the battery holster, grasp the cables connector body and
pull straight out. Do not try to remove the power cable from the LED Headlight module as
this connection is fixed.
Next, place the headband on your head; you can make size adjustments by turning the
knob on the rear of the headband until it feels comfortable. For more comfort you can
adjust the cross band.
Once the headlight module and cable are connected, the unit is ready for use.
The system comes with gown clips to relieve the weight of the cable from the headband.
One gown clip is attached below the shoulder.

4. MAINTENANCE

Storing the headlight system in a safe place will prolong the life of the unit.
The following guidelines will help in sustaining the headlight system useful life:
Keep the optical faces of the LED Headlight from touching hard surfaces,
•
which may cause scratches on the surface. Scratches on the surface will
diminish the light output.

5. CLEANING

The headlight module can be wiped down with alcohol. The lens should be cleaned only
with lens tissue, available in any camera store; follow the directions on the package.
Follow all applicable bloodborne pathogen procedures as required by OSHA and/or your
hospital, when cleaning and disinfecting the product.
The headband can be cleaned with an alcohol wipe down or washed with a
lukewarm solution of water and mild detergent. Rinse thoroughly.
®
LIT-171 CUDA SURGICAL
(English)
Rev. D
Date of Revision:3/28/13
Page 4 of 49