LENCO DAR-050 Mode D'emploi page 10

3. Select a desired track by using the Skip up
4. Press the Memory button (16) to enter the track into the memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press "Play/Pause
play the disc in the order you have programmed.
7. Press "Stop " button (4) to terminate program play.
 Press "Stop " button twice (4) at CD stop mode to cancel all programmed memory until the
"MEM" indicator disappear on LCD display (1).
 For MP3 disc/file, press the "Folder up" button on remote control to select the 1
next folder directly and hence to speed up the song selection.
 The programming mode will automatically stop if no button is being pressed in a period of
about 10 seconds after pressing the Memory button (16).
Remark:-
MP3 track format requirement:-
Bit rate: 32 kbps~320kbps, sampling rate: 32kHz, 44.1kHz and 48 kHz decodable
-
The performance of playing MP3 disc is various from the quality of recording disc and the
-
method of recording. Furthermore, the searching lead-time for MP3-CD is longer than
normal CD due to difference format.
Playback of MP3 song via USB storage media
Connecting
The system is able to decode and playback all MP3 file which stored in the memory media with
USB connecting port.
1. Set the system at Standby mode first or other function except USB mode.
2. Plug-in the USB pen-drive with the face up & make sure it going into completely.
 Connecting the USB upside down or backwards could damage the audio system or the
storage media (USB thumb driver). Check to be sure the direction is correct before
connection.
3. Turn on the unit again by On/standby button (5) and set press Function butt on (7) to select
USB mode. The system will start reading the storage media automatically after connecting,
and LCD display (1) will show the total number of MP3 files being detected.
4. Repeat the same playback procedure as playing CD/MP3 disc as above.
Remark
The system can detect and read the file under MP3 format only at USB mode but not other
-
music file format.
If connect the system to MP3 player via the USB socket, due to variances in file system
-
format, some MP3 player may not be able to play via the USB socket. This is not a
malfunction of the system.
USB port does not support connection with USB extension cable and is not designed for
-
communication with computer directly
Aux-in connection
Connect another audio device, e.g. (portable) CD player, MP3 player, (portable) cassette player,
iPod, etc. To this system via a cord with 3.5mm dia jack plugs (not supplied). Connect one end of
this cord to the headphone jack of the external device and the other end to the aux-in jack (9) at
/Skip down buttons (13/12).
10
" button (3) to
st
track of