emmeti SensoStar Instructions De Montage Et Manuel D'utilisation page 32

5 Detachable Calculator
We also provide meters with detachable calculators, in order to simplify
mounting in narrow installation spaces. To release the calculator pull it carefully
up off the flow sensor.
For mounting the calculator on the wall, a wall support is latched onto the
adapter of the flow sensor (between calculator and flow sensor). Remove the
calculator. Hold the adapter of the flow sensor and rotate the wall mounting
support anticlockwise until you can release it. Then attach the wall support at the
desired place with the flat surface towards the wall.
We always recommend detaching the calculator from the flow sensor.
However, it is important to note that the calculator must be detached for the following versions:
- Cooling and heat/cooling meters
- high temperature heat meter versions
- high temperature heat/cooling meter versions
6 Mounting the Temperature Sensors
During installation of two exterior temperature sensors (symmetrical) make sure that the (right) temperature
sensor with the following drawing is mounted into the same pipe line as the flow sensor:
Page 32 of 78 Article no.: 1080621023
SensoStar U
(temperature range up to 130 °C)
SensoStar U
(temperature range up to 120 °C).
2022_02_14 Subject to technical change! Errors excepted.