Kichler 39502 Mode D'emploi page 7

OPERATING INSTRUCTIONS
Dial Adjustment:
• When power is first applied, the light will
initialize for 45 seconds and then will be in Test
Mode. The Test Mode will last for 5 minutes.
The motion sensor adjustment dials (G)
consist of two knobs to adjust Sensitivity and
delay Timer. During the Test Mode, adjust the
sensitivity to the desired distance using the
Sensitivity knob Note: The sensitivity was
pre-set to the 40-ft. maximum at the factory;
turn the knob counterclockwise to decrease
the sensitivity -- down to 5 ft.
• The sensor is more sensitive to motions
across its detection path rather than the
motions directly towards it. Walk at normal
speed across the detection area to determine
desired detection distance.
• After 5 minutes in Test Mode the sensor will
enter Auto Mode. Once in Auto Mode, the
delay Timer can be set using the Timer knob.
• The light will stay ON as long as the motion is
detected. Once movement has stopped, the
light will turn OFF after the delay time has
elapsed. Note: The light was pre-set in the
factory to come on for 5 seconds every time
motion is detected; turn the knob clockwise to
increase the time – up to 180 seconds.
Mode Activation
Works At
Activated by
(Adjusted by
Sensitivity Knob)
On time
Shut-off delay
(Adjusted by
Timer Knob)
TEST MODE
When power is applied the sensor
will initialize for 45 seconds and then
will be in Test Mode.
Day and Night
Motions
Motion activated
5 seconds
A
The sensor switches to Auto
Mode 5 minutes after power
7
G
G
AUTO MODE
is applied.
Night Only
Motions
Motion activated
5 seconds~180 seconds